![]() other things that may be using 8P8C include.(in home use you can often get away with mixing this, but) technically, there are different plugs for braided and solid-copper wiring, that clamp/pierce the wire in different ways (see e.g.(optional: put some solid glue in the socket, to spread force when accidentally pulling the cable).use the crimping tool, which shoves the sharp part of the pins into the wires.check that all the wires go to the end (seeing shiny copper from the tip is a good sign).insert into plug (check the order again, they may have jumped around and checking is faster than redoing).And you want to do that at this stage, because ordering them will change length a little. ![]() which means the wires should stick out ~15mm from the sheath. Ideally, the outer insulation should make it into the plug far enough so that the crimping digs into it providing a little more protection when you accidentally pull the cable. cut them to equal length (if more than slightly different).order them according to the colors you want.Untangle the wire ends, so that they won't pull back when crimpedįor ≥1gBit it is suggested that you keep the untwisted length as small as possible, to minimize near-end crosstalk.Cut the outer insulation (that holds the cables together).Any gigabit-capable NIC can do this crossover internally, making life simpler and these cables mostly unnecessary) There were useful in the 10/100 era when switches were pricy, and you wanted to connect a NIC to another NIC directly. (The other type is a crossover cable (568A-to-568B). (568A-to-568A is functionally identical, but just confusing) You care mainly about 568B., because yout typically want to make a straight cable, a.k.a. Wires go to the end (can see wires, even its copper reflecting) (left).Īnd preferably enough of the jacket there to clamp down on, ideally more than here (right) With pin positions are counted from left to right with the contacts pointing up, clip on the back, and the and pointing up (cable coming out the bottom ): Used by Used byĬolor ( 568B) Pin Color(568A) 10/100Mbit 1Gbit/10gBit (.for the pedants: mainly for 10Base-T, 100BaseTX, and 1000Base-T which are but three of a good deal more methods of transmitting Ethernet, but the others are much less relevant to consumer networking) What you were probably looking for: Ethernet 1 What you were probably looking for: Ethernet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |